Belchfire - The High Temperature Torch

Belchfire Corp^®

TORCH STAND
Stand allows the operator to use the Belchfire torch without having to hold the torch. Operator's hands are free to light the torch and adjust the valve or valves for proper flame adjustment. The torch can be adjusted in the height from 3 to 48 inches. A torch clamp is required.

TORCH CLAMP
Clamp allows Belchfire torches to be mounted on Belchfire torch stands or any pipe nipple measuring 3/8" or less.

HIGH VOLUME REGULATOR
Designed to reduce gas pressure down to between 1 and 45 PSIG. The regulator provides higher flow capacity at lower pressures than most similar type regulators. The regulator comes with fittings and gauge for instant hookup to tanks containing LP gases, propylene or MAPP. Fittings can be replaced to adapt to high-pressure lines in plants using bulk fuel. Not designed for use with acetylene.

HAND LEVER PILOT VALVE
Valve is available for Belchfire's fuel only torches. This valve is used when a pilot flame is required on the torch. When in use the operator need not have to light the torch each time a heating flame is required. Manual operation of the valve is required by the operator.

SINGLE LINE FUEL HOSE - GRADE T
Hose can be used with most current fuel gases including LP gases, propylene, Natural gas and MAPP gas. The tube and cover are oil and flame resistant. The hose meets or exceeds RMA/CGA IP-7-90 standard for grade T hose. The cover is ribbed red and the tube is non-blooming. Available in 3/8 and 1/2 inch diameters (fittings included).

REVERSE FLOW CHECK VALVE
Designed for use with all Belchfire torches that operate at low pressure but require high flow rates. Check valves are designed to prevent reverse flow of gas or air. They do not stop flashbacks. Check valves meet or exceed CGA and OSHA requirements. For maximum flow the check valves are designed with 1/2" NPT fittings.

AUTOMATIC SHUT OFF VALVE WITH THERMOCOUPLE
Valve is designed for industrial applications with gas pressure of up to and including 25psi. Valve is suitable for use with Natural gas, LP gases, propylene, MAPP or gas-air mixtures. Valve provides safe lighting and complete shut off of burner gas flow when a flameout occurs. Thermocouple is provided with valve but torch requires a combustion chamber equipped with thermocouple adaptor. Valve and thermocouple are installed and ready for use when ordered with a Belchfire torch.